Genie ZX-135/70 Service Manual page 88

August 2014
4 Install the bolt that was just removed into the
anchor hole to secure the engine pivot plate
from moving.
Crushing hazard. Failure to
install the bolt into the engine
pivot plate to secure it from
moving could result in death or
serious injury.
5 Confirm that each turntable mounting bolt is
torqued in sequence to specification. Refer to
Specifications, Machine Torque
Specifications.
Bolt torque sequence (from above turntable)
6 Lower the secondary boom to the stowed
position.
Part No. 218700
Checklist D Procedures
7 Remove the engine pivot plate retaining
fastener from the engine pivot plate anchor
hole at the pivot end of the engine pivot plate.
8 Swing the engine pivot plate in towards the
machine.
9 Install the bolt that was just removed into the
original hole to secure the engine pivot plate.
10 Confirm that each bearing mounting bolt
under the drive chassis is torqued in
sequence to specification. Refer to
Specifications, Machine Torque
Specifications.
Bolt torque sequence (from below turntable)
ZX-135/70
Service Manual
Crushing hazard. Failure to
install the bolt into the engine
pivot plate to secure it from
moving could result in death or
serious injury.
73