Sensor - Motorola WS5100 Series Cli Reference Manual

20-40 WS5100 Series Switch CLI Reference Guide
Example
WS5100(config-wireless)#self-heal interference-avoidance enable
WS5100(config-wireless)#
WS5100(config-wireless)#self-heal interference-avoidance hold-time
600
WS5100(config-wireless)#
WS5100(config-wireless)#self-heal neighbor-recovery enable
Note: reducing the configured transmit power of radios will ensure
that there is room to increase power when a neighbor fails
WS5100(config-wireless)#
WS5100(config-wireless)#self-heal neighbor-recovery neighbors 1 1
WS5100(config-wireless)#

20.1.33 sensor

Wireless Configuration Commands
Configures Wireless Intrusion Protection System (WIPS) parameters
Syntax
sensor(<1-48>|default-config|ping-interval <2-60>|vlan)
sensor <1-48> [default-config|request-config|revert-to-ap]
sensor default-config(ip-mode|wips-server-ip)
sensor default-config ip-mode(dhcp|static(A.B.C.D/M)(A.B.C.D))
sensor default-config wips-server-ip(primary|secondary)(A.B.C.D)
Parameters
<1-48> [defaultconfig|
requestconfig|
revert-to-ap]
Select a sensor to reset/revert the AP to its original state.
Use the
show wireless sensor
sensor index
• default-config – Restores the internal configuration of
the sensor to default values. This sends the
configuration to the sensor
• request-config – Polls the sensor for its latest
configuration
• revert-to-ap – Reverts an IDS sensor back to an access
port that can service mobile-units
command to view the