Static-Channel-Group - Motorola WS5100 Series Cli Reference Manual

12-18 WS5100 Series Switch CLI Reference Guide
Parameters
10
100
1000
auto
Usage Guidelines
Set the interface speed to auto to detect and use the fastest speed available. Speed
detection is based on connected network hardware
Example
WS5100(config-if)#speed auto
WS5100(config-if)#

12.1.18 static-channel-group

Interface Config Commands
Adds an interface to a static channel group
Syntax
static-channel-group <1-2>
Parameters
<1-2>
Usage Guidelines
This command aggregates individual giga port's into a single aggregate link to provide a
larger bandwidth. The static channel group is used to provide additional bandwidth in
multiples of 1Gbps on the switch. All MAC layer and higher protocols see only the static
channel group (aggregate link) rather than the individual ports that comprise it.
Example
WS5100(config-if)#static-channel-group 2
WS5100(config-if)#
Forces 10 Mbps operation
Forces 100 Mbps operation
Forces 1000 Mbps operation
Port automatically detects the speed it should run based on
the port at the other end of the link
Sets a static channel group to associate the link with