Mark - Motorola WS5100 Series Cli Reference Manual

15.1.6 mark

Standard ACL Config Commands
Specifies packets to mark
Syntax
mark(8021.1p<0-7>|tos<0-255>)(A.B.C.D/M|any|host)
mark(8021.1p<0-7>|tos<0-255>)any|host(log|rule-precedence<1-5000>|
|A.B>C.D)
Parameters
8021.1p<0-7>|tos<0-255>)
(A.B.C.D/M|any|host)
any
host
(log|rule-precedence<1-
5000>||A.B>C.D)
Usage Guidelines
Use this command to mark traffic from the source network/host. Use the mark option to
specify the type of service (TOS) and priority value. The TOS value is marked in the IP
header. The 802.1p priority value is marked in the frame.
When the interface receives the packet, its content is checked against the ACEs in the
ACL. It is marked based on the ACL configuration.
• Specifies .1p priority value between 0 and 7
• Specifies a Type of Service (tos) value between 0 and
255
source is the source IP address of the network or host in
dotted decimal format. Source-mask is the network mask.
For example, 10.1.1.10/24 indicates the first 24 bits of the
source IP are used for matching
any is an abbreviation for source IP of 0.0.0.0 and source-
mask bits equal to 0
host is an abbreviation for the exact source (A.B.C.D) and
source-mask bits equal to 32
NOTE: The log option is functional only for router ACLs. The log option
results in an informational logging message about the packet matching
the entry sent to the console.
Standard ACL Instance 15-5