Service - Motorola WS5100 Series Cli Reference Manual

default-config
(ip-mode|wips-server-ip)
ping-interval <2-60>
vlan<1-4094>
Example
WS5100(config-wireless)#sensor vlan 268 500
WS5100(config-wireless)#

20.1.34 service

Wireless Configuration Commands
Invokes service commands to troubleshoot or debug
configurations
Syntax
service(show|wireless)
service show(cli|wireless)
Invokes the default configuration sent to sensors when
configured
• ip-mode – Configures the IP address of the sensors
• dhcp – Sensors use DHCP to obtain an
IP address
• static (A.B.C.D/M)(A.B.C.D) – Sensors use
the specific static IP address
A.B.C.D/M – Sets the sensor IP address and
network mask
A.B.C.D – Specifies the gateway IP address
for sensors
• wips-server-ip – Specifies the IP addresses of the WIPS
server
• primary (A.B.C.D) – Specifies the primary IP
address of the WIPS server
• secondary (A.B.C.D) – Specifies the
secondary IP address of the WIPS server
Sets the ping interval (in seconds) between successive
pings to sensors on the network
Configures VLANs where sensors are discovered
Wireless Instance
(config-wireless)
20-41
instance