Permit - Motorola WS5100 Series Cli Reference Manual

14.1.8 permit

Extended ACL Config Commands
Permits specific packets
Syntax
permit {ip} {source/source-mask | host source | any} {destination/
destination-mask
access-list-entry precedence]
permit {icmp} {source/source-mask | host source | any}
{destination/ destination-mask | host destination | any} [icmp-type
| [icmp-type icmp-code]] [log] [rule-precedence access-list-entry
precedence]
permit{tcp|udp} {source/source-mask | host source | any} [operator
source-port] {destination/destination-mask | host destination |
any} [operator destination-port] [log] [rule-precedence access-
list-entry precedence]
NOTE: ACLs do not allow DHCP messages to flow by default. Configure
an Access Control Entry (ACE) to allow DHCP messages to flow through.
WS5100(config-ext-nacl)#permit ip xxx.xxx.xxx.xxx/x
192.168.2.0/24
WS5100(config-ext-nacl)#permit ip any host
xxx.xxx.xxx.xxx
WS5100(config-ext-nacl)#
| host destination | any} [log] [rule-precedence
Extended ACL Instance 14-13