Configuring The Radius Server Settings - NETGEAR ProSafe WG302 Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302

Configuring the Radius Server Settings

Use the following steps to view or change the Radius Server Settings.
1. Connect to the WG302.
In the address field of your Web browser,
enter the default LAN address of
http://192.168.1.128.
name of admin and default password of
password, or log in by using the LAN address
and password that you configured.
2. In the Security menu, click Radius Server
Settings.
3. Enter the settings, and click Apply.
The Radius Server Settings are explained below:
• Authentication/Access Control Radius
Server Configuration. This configuration is
required for authentication using Radius. IP
Address, Port No. and Shared Secret is
required for communication with Radius
Server. A Secondary Radius Server can be
configured which is used on failure on
Primary Radius Server
• IP Address. The IP address of the Radius
Server. The default is 0.0.0.0.
• Port Number. Port number of the Radius Server. The default is 1812.
• Shared Secret. This is shared between the Wireless Access Point and the Radius Server while
authenticating the supplicant.
• Re-authentication Time. The time interval in seconds after which the supplicant will be
authenticated again with the Radius Server. The default is 3600 seconds.
• Global-key Re-Key Time. Select this option to enable Re-keying of Global Key. The Global
Key Re-Key can be done based on time interval in seconds or number of packets exchanged
using the global key. The default is 3600 seconds.
Basic Installation and Configuration
Log in with the user
v0.1, December 2005
Figure 3-10
3-19