Configuring A Point-To-Multi-Point Wireless Bridge - NETGEAR WNAP320 Reference Manual

ProSafe Wireless-N Access Point WNAP320 Reference Manual

Configuring a Point-to-Multi-Point Wireless Bridge

Figure 8. To configure a point-to-multi-point wireless bridge as shown in
Select Configuration > Wireless Bridge > Bridging and Repeating. The Bridging and
1.
Repeating screen displays.
Figure 9.
Configure the operating mode of the access points:
2.
Configure WNAP320 (AP1) on LAN Segment 1 in point-to-point bridge mode with the
•
remote MAC address of AP2.
Because it is in the central location, configure WNAP320 (AP2) on LAN Segment 2 in
•
Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are
required in AP2.
Configure the WNAP320 (AP3) on LAN 3 in Point-to-Point Bridge mode with the
•
Remote MAC Address of AP2.
Verify the following parameters for all access points:
3.
Verify that both access points are configured to operate in the same LAN network
•
address range as the LAN devices.
Only one access point is configured in Point-to-Multi-Point Bridge mode, and all the
•
others are in Point-to-Point Bridge mode.
Chapter 4. Advanced Configuration
Figure 9, :
| 31