Requesting Remote Support - Leica iNEX User Manual

9.1.1 Disconnecting from Virtual Wrench
The iNEX can continue to be used while connected to the Virtual Wrench
service. While the system is connected a wrench symbol will be displayed
on the AutoSTEER Status button
The system will automatically disconnect from Virtual Wrench
turned OFF, alternatively the operator may manually disconnect.
1. Press the GPS Status button
2. Press OPTIONS.
3. Press DISCONNECT.
9.2

Requesting Remote Support

Once connected to the Virtual Wrench
trained technician is available at the press of a button. Once support is
requested the technician can view important information about the
system before calling the phone number entered.
1. Press the GPS Status button
2. Press
OPTIONS
3. Press
REQUEST SUPPORT
4. Enter a contact phone number using
the on-screen keyboard and press
TICK.
iNEX User Manual
.
.
TM
service, Remote Support from a
Page 77
TM
TM
TM
when it is
Rev 2