Autosteer; Configuring Autosteer - Leica iNEX User Manual

8 AutoSTEER

AutoSTEER is an optional feature which is enabled when AutoSTEER is
purchased. Along with the feature unlock code (see 7.1 Enabling New
Options) a compatible AutoSTEER controller is also required.
Full instructions for the set up and use of the specific AutoSTEER
controllers are documented in a separate manual supplied with each
controller.
The following sections briefly describe the general use and setup of the
AutoSTEER system.
8.1

Configuring AutoSTEER

8.1.1 Set Up the Vehicle
Once the AutoSTEER feature has been enabled the steer controller needs
to be selected and AutoSTEER turned ON.
1. Configure the Steer Controller setting for
the Rig which has the steer controller
installed. See 3.5.2.2 Configure Advanced
Settings (Steer Control).
2. From the Main menu press SETUP.
3. Press AUTOSTEER.
4. Press the AutoSTEER
repeatedly until it displays ON.
8.1.2 Tune AutoSTEER
Each AutoSTEER controller has specific tuning
requirements and the specific instructions
supplied with the controller should be read. To
access the tuning screen press and hold down
the AutoSTEER Status button for three seconds.
iNEX User Manual
button
ON/OFF
Page 73 Rev 2