Using Autospray - Leica iNEX User Manual

10.3 Using AutoSPRAY

Once properly calibrated using AutoSPRAY is as simple as driving and
turning on the master switch. Some details of how to use AutoSPRAY will
depend on the flow controller which is being used. In most situations if
the flow controller is a voltage controller then the section switches on the
flow controller should be left in the OFF position while the master switch
is left in the ON position. Most flow controllers which communicate over
serial or CANbus will require the section switches to be left in the ON
position.
10.3.1 Normal Operation
During normal operation the AutoSPRAY Status button will be coloured
blue and green. When the vehicle passes over a previously treated area
the iNEX will automatically turn the overlapping sections OFF. On leaving
the treated area the iNEX will automatically turn the relevant sections
back ON.
10.3.2 Switching to Manual Control
From time to time it may be necessary to manually control the state of
implement sections. To do this there are two options, switch to manual
control or use the AutoSPRAY Override function. Provided the system is
properly configured for the connected flow controller, switching to manual
control turns automatic control of the sections off, and the iNEX simply
detects the sections which are manually being used on the controller.
For manual section detection to work the Section Switches setting must
be set to External. AutoSPRAY must be OFF
before the Section Switches setting can be
changed. See 3.5.3.2 Section Switches.
To change from AutoSPRAY to manual
control, simply turn AutoSPRAY OFF by
pressing on the AutoSPRAY Status button
on the Main Menu. The AutoSPRAY Status
button will change to white.
Page 84 Rev 2
iNEX User Manual