Installing The Inex Display - Leica iNEX User Manual

2.2

Installing the iNEX Display

1. Read all instructions before attempting installation.
2. Attach the RAM mount arm, and separate RAM mount ball to the
RAM mount on the iNEX Display.
3. Pick a suitable location to mount
the Display by holding it up in
place while checking for visibility
out of the vehicle. The Display
needs to be within easy reach of
the operator when seated in the
normal operating position, and
ideally it will be easily visible in
the forward vision of the
operator.
4. When a suitable location to
mount the Display has been selected, mark the position of where
the RAM mount ball is to be mounted on the vehicle.
Note: There are a number of different RAM mounts available, including clamp on
brackets, which may simplify the installation. RAM mount arms are also available in a
number of different lengths; please contact your point of purchase.
5. Secure the RAM mount ball to the vehicle in the required location.
Important: Use extreme caution whenever drilling holes or attaching
any objects to the vehicle as there may be hidden cables or hoses.
Never drill into the ROP system of any vehicle as this may damage
the integrity of the system. Consult the vehicle's operating manual
prior to drilling any holes.
6. Attach the Display to the RAM mount ball using the RAM mount arm.
Once the Display is oriented in the correct direction, ensure the RAM
mount is tightly secured.
iNEX User Manual
Page 6 Rev 2