Leica iNEX User Manual page 31

3.5.3.2 Section Switches
1. From the Main menu press SETUP.
2. Press
VEHICLE
3. Press
SWITCH
4. Touch on the Section Switches
button until the required setting is
displayed.
None By default the Section Switches are configured to None.
When configured as None all of the sections will be set to
ON causing the treatment to always be recorded as a full
swath width.
External When configured for External the Section state will be
updated from a compatible flow controller if selected or by
sensing the voltage on the AutoSPRAY Voltage port if
connected.
AutoSPRAY The system will automatically configure the Section Switches
to AutoSPRAY when AutoSPRAY is enabled and turned ON.
This will allow the iNEX to automatically control the state of
the sections.
iNEX User Manual
SETUP.
SETUP.
Page 24 Rev 2