Getting Started; Starting The Inex - Leica iNEX User Manual

3 Getting Started

3.1

Starting the iNEX

Prior to starting with this manual the iNEX should be completely installed
into the vehicle in accordance with the instructions in the iNEX installation
manual. When power is connected the iNEX Display will emit two short
beeps. This will not immediately start the iNEX Display.
The iNEX may be started or shut down in either of two ways:
• Pressing the power button on the top of the iNEX Display.
• Vehicle ignition (using the optional 3 wire power cable Part# 1-2406)
3.1.1 Using the Power button
Using the standard 2 wire power cable (Part# 1-2408) the iNEX can only
be turned ON using the power button.
To turn the iNEX ON simply press the power button, located on the far left
top of the iNEX Display, and one long beep will be heard. Release the
power button.
3.1.2 Using the Vehicle Ignition
If the iNEX has been correctly installed using the optional 3 wire power
cable, the system will start up when the ignition key is turned ON. No
user intervention is required.
iNEX User Manual
Page 11 Rev 2