Setting The Gps Source Options - Leica iNEX User Manual

7.2

Setting the GPS Source Options

Depending on the options purchased the iNEX can work with many
different sources of GPS.
By default the system will be configured to work with a GPS receiver
supplying NMEA information via a serial connection at 19200 baud.
Optionally the system can be configured to use NMEA2000 or John Deere
CANbus GPS information supplied via a CANbus connection.
1. From the Main menu press SETUP.
2. Press MORE.
3. Press
GPS SETUP.
4. Press the Connection Type button
repeatedly until the desired setting is
displayed.
5. If connection type is serial, press the
GPS Baud button repeatedly until the
desired setting is displayed.
Note: The Connection Type and GPS Baud rate must match the GPS receiver being used for the
system to receive positioning information.
Note: When using a serial connection the receiver must have the NMEA settings configured to
output GPGGA strings at 5Hz.
Note: When the mojoRTK console is selected as the Steering Controller the Connection Type will
be locked to mojoRTK.
iNEX User Manual
Page 66 Rev 2