Examples
# Enable the IPv6 multicast group replacement function globally in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] overflow-replace vlan 2
report-aggregation (MLD-snooping view)
Syntax
report-aggregation
undo report-aggregation
View
MLD-snooping view
Default level
2: System level
Parameters
None
Description
Use report-aggregation to enable MLD report suppression.
Use undo report-aggregation to disable MLD report suppression.
By default, MLD report suppression is enabled.
This command works in both MLD snooping–enabled VLANs and VLANs with MLD enabled on their
VLAN interfaces.
Examples
# Disable MLD report suppression.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] undo report-aggregation
reset mld-snooping group
Syntax
reset mld-snooping group { ipv6-group-address | all } [ vlan vlan-id ]
View
User view
Default level
2: System level
Parameters
ipv6-group-address: Specifies an IPv6 multicast group. The value range of ipv6-group-address is
FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y represent any
hexadecimal number between 0 and F, inclusive.
248