Timer Hello (Pim View) - HP 6125G Command Reference Manual

Parameters
rp-address: Specifies the IP address of the static RP to be configured. This address must be a real, valid
unicast IP address, rather than an address on the 127.0.0.0/8 segment.
acl-number: Specifies a basic ACL number, in the range of 2000 to 2999. If you provide this argument,
the configured static RP will serve only those groups that pass the ACL filtering. Otherwise, the configured
static RP will serve the all-system group 224.0.0.0/4.
preferred: Gives priority to the static RP if the static RP conflicts with the dynamic RP. If you do not include
the preferred keyword in your command, the dynamic RP receives priority, and the static RP takes effect
only if no dynamic RP exists in the network or when the dynamic RP fails.
Description
Use static-rp to configure a static RP.
Use undo static-rp to configure a static RP.
By default, no static RP is configured.
PIM-SM or PIM-DM cannot be enabled on an interface that serves as a static RP.
When the ACL rule applied on a static RP changes, a new RP must be elected for all the multicast groups.
You can configure multiple static RPs by using this command repeatedly. However, if you use this
command multiple times and specify the same static RP address or reference the same ACL rule, the last
configuration overrides the previous one. If you have configured multiple static RPs for the same multicast
group, the one with the highest IP address serves the multicast group.
You can configure up to 50 static RPs on the same device.
Related commands: auto-rp enable and display pim rp-info.
Examples
# Configure the interface with the IP address 1 1.1 10.0.6 to be a static RP that serves the multicast groups
in the address range of 225.1.1.0/24 defined in ACL 2001, and give priority to this static RP in the case
of static/dynamic RP conflict.
<Sysname> system-view
[Sysname] acl number 2001
[Sysname-acl-basic-2001] rule permit source 225.1.1.0 0.0.0.255
[Sysname-acl-basic-2001] quit
[Sysname] pim
[Sysname-pim] static-rp 11.110.0.6 2001 preferred

timer hello (PIM view)

Syntax
timer hello interval
undo timer hello
View
PIM view
Default level
2: System level
143