Subvlan (Ipv6 Multicast Vlan View) - HP 6125G Command Reference Manual

Use undo port multicast-vlan ipv6 to restore the default.
By default, a port does not belong to any IPv6 multicast VLAN.
A port can belong to only one IPv6 multicast VLAN.
Examples
# Assign GigabitEthernet 1/0/1 to IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port multicast-vlan ipv6 100

subvlan (IPv6 multicast VLAN view)

Syntax
subvlan vlan-list
undo subvlan { all | vlan-list }
View
IPv6 multicast VLAN view
Default level
2: System level
Parameters
vlan-list: Specifies a VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094.
all: Specifies all the sub-VLANs of the current IPv6 multicast VLAN.
Description
Use subvlan to configure sub-VLANs for the current IPv6 multicast VLAN.
Use undo subvlan to remove the specified sub-VLANs or all sub-VLANs from the current IPv6 multicast
VLAN.
An IPv6 multicast VLAN has no sub-VLANs by default.
The VLANs to be configured as the sub-VLANs of the IPv6 multicast VLAN must exist and must not be IPv6
multicast VLANs or sub-VLANs of any other IPv6 multicast VLAN.
The number of sub-VLANs of the IPv6 multicast VLAN must not exceed the system-defined limit.
Examples
# Configure VLAN 10 through VLAN 15 as sub-VLANs of IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100] subvlan 10 to 15
254