Mld-Snooping Host-Aging-Time; Mld-Snooping Host-Join - HP 6125G Command Reference Manual

mld-snooping host-aging-time

Syntax
mld-snooping host-aging-time interval
undo mld-snooping host-aging-time
View
VLAN view
Default level
2: System level
Parameters
interval: Specifies an aging timer for dynamic member ports in seconds. The value range is 200 to 1000.
Description
Use mld-snooping host-aging-time to set the aging timer for the dynamic member ports for a VLAN.
Use undo mld-snooping host-aging-time to restore the default.
By default, the aging timer of a dynamic member port is 260 seconds.
This command takes effect only if MLD snooping is enabled for the VLAN.
Related commands: display mld-snooping host, host-aging-time and mld-snooping enable.
Examples
# Enable MLD snooping and set the aging timer for dynamic member ports to 300 seconds in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping host-aging-time 300

mld-snooping host-join

Syntax
mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
undo mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
ipv6-group-address: Specifies the address of the IPv6 multicast group that the simulated host will join. The
value ranges from FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y
represent any hexadecimal number between 0 and F, inclusive.
ipv6-source-address: Specifies the address of the IPv6 multicast source that the simulated host will join.
235