Multicast Ipv6 Forwarding-Table Downstream-Limit - HP 6125G Command Reference Manual

site-local: Specifies the scope zone as site-local, which has a scope ID of 5.
all: Deletes all IPv6 multicast boundaries configured on the interface.
Description
Use multicast ipv6 boundary to configure an IPv6 multicast forwarding boundary.
Use undo multicast ipv6 boundary to delete the specified IPv6 multicast forwarding boundary or all IPv6
multicast forwarding boundaries.
By default, no multicast forwarding boundary is configured.
A multicast forwarding boundary sets the boundary condition for the IPv6 multicast groups in the
specified address range. If the destination address of an IPv6 multicast packet matches the set boundary
condition, the packet is not forwarded.
An interface can act as a forwarding boundary for multiple IPv6 multicast groups in different address
ranges. You can implement this by using this command on the interface for each multicast address range.
These multicast groups must be in the same scope. The latest configuration of a scope overwrites the
previous one.
Assume that Set A and Set B are both multicast forwarding boundary sets with different address ranges,
and that B is a subset of A. If B is configured after A, A still takes effect. If A is configured after B, B will
be removed.
Related commands: display multicast ipv6 boundary.
Examples
# Configure VLAN-interface 100 to be the forwarding boundary of the IPv6 multicast groups in the range
of FF03::/16.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] multicast ipv6 boundary ff03:: 16
# Configure VLAN-interface 100 to be the forwarding boundary of the IPv6 multicast groups in the
admin-local scope.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] multicast ipv6 boundary scope 4

multicast ipv6 forwarding-table downstream-limit

Syntax
multicast ipv6 forwarding-table downstream-limit limit
undo multicast ipv6 forwarding-table downstream-limit
View
System view
Default level
2: System level
Parameters
limit: Specifies the maximum number of downstream node (the maximum number of outgoing interfaces)
for a single entry in the IPv6 multicast forwarding table. The value ranges from 0 to 128.
262