Related commands: multicast routing-enable.
Examples
# Enable IP multicast routing, and enable MSDP to enter MSDP view.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] msdp
[Sysname-msdp]
originating-rp
Syntax
originating-rp interface-type interface-number
undo originating-rp
View
MSDP view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use originating-rp to configure the address of the specified interface as the RP address of SA messages.
Use undo originating-rp to restore the default.
By default, the PIM RP address is used as the RP address of SA messages.
Examples
# Specify the IP address of VLAN-interface 100 as the RP address of SA messages.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] originating-rp vlan-interface 100
peer connect-interface
Syntax
peer peer-address connect-interface interface-type interface-number
undo peer peer-address
View
MSDP view
Default level
2: System level
Parameters
peer-address: Specifies an MSDP peer address.
154