Ssm-Policy (Ipv6 Pim View) - HP 6125G Command Reference Manual

Parameters
group-policy acl6-number: Specifies a basic IPv6 ACL number, in the range of 2000 to 2999. If you do
not include this option in your command, the configuration applies to all IPv6 multicast groups.
order order-value: Specifies the order of the IPv6 ACL in the group-policy list, where order-value has an
effective range of 1 to (the largest order value in the existing group-policy list + 1), but the value range
should not include the original order value of the IPv6 ACL in the group-policy list. If you have assigned
an order-value to a certain IPv6 ACL, do not specify the same order-value for another IPv6 ACL.
Otherwise the system gives error information. If you do not specify an order-value, the order value of the
IPv6 ACL remains the same in the group-policy list.
Description
Use spt-switch-threshold infinity to disable the switchover to SPT.
Use undo spt-switch-threshold to restore the default.
By default, the device switches to the SPT immediately after it receives the first IPv6 multicast packet.
To adjust the order of an IPv6 ACL that already exists in the group-policy list, you can use the acl6-number
argument to specify this IPv6 ACL and set its order value. This inserts the IPv6 ACL to the position of
order-value in the group-policy list. The order of the other existing IPv6 ACLs in the group-policy list
remains unchanged.
To use an IPv6 ACL that does not exist in the group-policy list, you can use the acl6-number argument to
specify an IPv6 ACL and set its order value. This inserts the IPv6 ACL to the position of order-value in the
group-policy list. If you do not include the order order-value option in your command, the ACL is
appended to the end of the group-policy list.
If you use this command multiple times on the same IPv6 multicast group, the first traffic rate configuration
matched in sequence takes effect.
If the switch is an RP, disabling switchover to SPT might cause multicast traffic forwarding failures on the
source-side DR. When disabling switchover to SPT, be sure you fully understand its impact on your
network.
Examples
# Disable the switchover to SPT on the receiver-side DR
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] spt-switch-threshold infinity

ssm-policy (IPv6 PIM view)

Syntax
ssm-policy acl6-number
undo ssm-policy
View
IPv6 PIM view
Default level
2: System level
Parameters
acl6-number: Basic IPv6 ACL number, in the range of 2000 to 2999.
349