Igmp-Snooping Max-Response-Time; Igmp-Snooping Overflow-Replace - HP 6125G Command Reference Manual

[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping leave source-ip 10.1.1.1

igmp-snooping max-response-time

Syntax
igmp-snooping max-response-time interval
undo igmp-snooping max-response-time
View
VLAN view
Default level
2: System level
Parameters
interval: Specifies the maximum response delay for IGMP general queries in seconds. The value ranges
from 1 to 25.
Description
Use igmp-snooping max-response-time to configure the maximum response delay for IGMP general
queries in the VLAN.
Use undo igmp-snooping max-response-time to restore the default.
By default, the maximum response delay for IGMP general queries is 10 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable, igmp-snooping query-interval, and max-response-time.
Examples
# Enable IGMP snooping and set the maximum response delay for IGMP general queries to 5 seconds
in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping max-response-time 5

igmp-snooping overflow-replace

Syntax
igmp-snooping overflow-replace [ vlan vlan-list ]
undo igmp-snooping overflow-replace [ vlan vlan-list ]
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
21