Mld Configuration Commands; Display Mld Group - HP 6125G Command Reference Manual

MLD configuration commands

The term "router" in this document refers to both routers and Layer 3 switches.

display mld group

Syntax
display mld group [ ipv6-group-address | interface interface-type interface-number ] [ static | verbose ]
[ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
ipv6-group-address: Specifies an MLD group address, in the range of FFxy::/16 (excluding FFx0::/16,
FFx1::/16, FFx2::/16, and FF0y::), where x and y represent any hexadecimal number ranging from 0 to
F. If you do not specify any IPv6 multicast group address, this command displays the information of all
MLD groups.
interface interface-type interface-number: Displays the information of MLD groups on the specified
interface. If you do not specify interface-type interface-number, the command displays the MLD group
information on all the interfaces.
static: Displays the information of static MLD group entries. If you do not specify this keyword, the
command displays the dynamic MLD group entries.
verbose: Displays detailed information of MLD groups.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display mld group to display information about MLD groups.
Examples
# Display detailed information about dynamically joined MLD groups on all interfaces.
<Sysname> display mld group verbose
Interface group report information
Vlan-interface1(FE80::101)
Total 1 MLD Groups reported
Group: FF03::101
268