Embedded-Rp - HP 6125G Command Reference Manual

Parameters
dscp-value: Specifies the DSCP value for IPv6 PIM messages, in the range of 0 to 63.
Description
Use dscp to set the DSCP value for IPv6 PIM messages.
Use undo dscp to restore the default.
The default DSCP value in IPv6 PIM messages is 48.
Examples
# Set the DSCP value to 63 for IPv6 PIM messages.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] dscp 63

embedded-rp

Syntax
embedded-rp [ acl6-number ]
undo embedded-rp [ acl6-number ]
View
IPv6 PIM view
Default level
2: System level
Parameters
acl6-number: Basic IPv6 ACL number, in the range of 2000 to 2999.
Description
Use embedded-rp to enable embedded RP.
Use undo embedded-rp to disable embedded RP or restore the default.
By default, embedded RP is enabled for IPv6 multicast groups in the default embedded RP address
scopes.
The default embedded RP address scopes are FF7x::/12 and FFFx::/12, where x represents any legal
address scope. For more information about the scope field, see Multicast overview.
When you use the embedded-rp command without specifying acl6-number, the embedded RP feature is
enabled for all the IPv6 multicast groups in the default embedded RP address scopes. If you specify
acl6-number, the embedded RP feature is enabled for only those IPv6 multicast groups that are within the
default embedded RP address scopes and pass the ACL check.
When you use the undo embedded-rp command without specifying acl6-number, the embedded RP
feature is disabled for all the IPv6 multicast groups. If you specify acl6-number, this command restores the
default.
Examples
# Enable embedded RP for only those IPv6 multicast groups in the address scope FF7E:140:20::101/64.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
327