HP 6125G Command Reference Manual page 59

Default level
1: Monitor level
Parameters
source-address: Specifies a multicast source address.
mask: Specifies the mask of the multicast source address.
mask-length: Specifies the mask length of the multicast source address, in the range of 0 to 32.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display multicast routing-table static to display information about multicast static routes.
Examples
# Display all multicast static routes.
<Sysname> display multicast routing-table static
Multicast Routing Table
Routes : 1
Mroute 10.10.0.0/16
Running Configuration = ip rpf-route-static 10.10.0.0 16 2.2.2.2 order 1
Table 10 Command output
Field
Mroute
Interface
RPF Neighbor
Route-policy
Preference
Order
Running Configuration
Interface = Vlan-interface1
Matched routing protocol = <none>, Route-policy = <none>
Preference = 1, Order = 1
Description
Multicast route source address and its mask length.
Outgoing interface to the multicast source.
IP address of the RPF neighbor through which the multicast source is reachable.
Routing policy. The multicast source address of the route should match the
routing policy.
Route preference.
Sequence number of the route.
Command line that configures the multicast static route.
RPF Neighbor = 2.2.2.2
47