Prune Delay (Pim View); Register-Policy (Pim View) - HP 6125G Command Reference Manual

Parameters
interval: Register probe time in seconds, with an effective range of 1 to 1799.
Description
Use probe-interval to configure the register probe time.
Use undo probe-interval to restore the default.
By default, the register probe time is 5 seconds.
Related commands: register-suppression-timeout.
Examples
# Set the register probe time to 6 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] probe-interval 6

prune delay (PIM view)

Syntax
prune delay interval
undo prune delay
View
PIM view
Default level
2: System level
Parameters
interval: Prune delay time in the range of 1 to 128 seconds.
Description
Use prune delay to configure the prune delay time, namely, the length of time that the device waits
between receiving a prune message and taking a prune action.
Use undo prune delay to restore the default.
By default, the prune delay is not configured.
Examples
# Set the prune delay time to 75 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] prune delay 75

register-policy (PIM view)

Syntax
register-policy acl-number
undo register-policy
135