pim ipv6 require-genid
Syntax
pim ipv6 require-genid
undo pim ipv6 require-genid
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim ipv6 require-genid to enable rejection of hello messages without Generation_ID.
Use undo pim ipv6 require-genid to restore the default.
By default, hello messages without Generation_ID are accepted.
Examples
# Enable VLAN-interface 100 to reject hello messages without Generation_ID.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 require-genid
pim ipv6 sm
Syntax
pim ipv6 sm
undo pim ipv6 sm
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim ipv6 sm to enable IPv6 PIM-SM.
Use undo pim ipv6 sm to disable IPv6 PIM-SM.
By default, IPv6 PIM-SM is disabled.
This command can take effect only after IPv6 multicast routing is enabled on the device.
Related commands: multicast ipv6 routing-enable and pim ipv6 dm.
340