mld-snooping max-response-time
Syntax
mld-snooping max-response-time interval
undo mld-snooping max-response-time
View
VLAN view
Default level
2: System level
Parameters
interval: Specifies the maximum response delay for MLD general queries in seconds. The value ranges
from 1 to 25.
Description
Use mld-snooping max-response-time to configure the maximum response delay for MLD general
queries in the VLAN.
Use undo mld-snooping max-response-time to restore the default.
By default, the maximum response delay for MLD general queries is 10 seconds.
This command takes effect only if MLD snooping is enabled for the VLAN.
Related commands: max-response-time, mld-snooping enable, and mld-snooping query-interval.
Examples
# Enable MLD snooping and set the maximum response delay for MLD general queries to 5 seconds in
VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping max-response-time 5
mld-snooping overflow-replace
Syntax
mld-snooping overflow-replace [ vlan vlan-list ]
undo mld-snooping overflow-replace [ vlan vlan-list ]
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
238