Spt-Switch-Threshold Infinity (Pim View) - HP 6125G Command Reference Manual

Use undo source-policy to remove the configured multicast data filter.
By default, no multicast data filter is configured.
If you specify a basic ACL, the device filters all the received multicast packets based on the source
address, and discards packets that fail the source address match. If you specify an advanced ACL, the
device filters all the received multicast packets based on the source and group addresses, and discards
packets that fail the match.
If this command is executed repeatedly, the last configuration takes effect.
Examples
# Configure the router to accept multicast packets that originate from 10.10.1.2 and discard multicast
packets that originate from 10.10.1.1.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.10.1.2 0
[Sysname-acl-basic-2000] rule deny source 10.10.1.1 0
[Sysname-acl-basic-2000] quit
[Sysname] pim
[Sysname-pim] source-policy 2000

spt-switch-threshold infinity (PIM view)

Syntax
spt-switch-threshold infinity [ group-policy acl-number [ order order-value ] ]
undo spt-switch-threshold [ group-policy acl-number ]
View
PIM view
Default level
2: System level
Parameters
group-policy acl-number: Specifies a basic ACL, in the range of 2000 to 2999. If you do not include this
option in your command, the configuration applies to all multicast groups.
order order-value: Specifies the order of the ACL in the group-policy list, where order-value has an
effective range of 1 to the largest order value in the existing group-policy list plus 1, but the value range
should not include the original order value of the ACL in the group-policy list. If you have assigned an
order-value to a certain ACL, do not specify the same order-value for another ACL. Otherwise, the system
gives error information. If you do not specify an order-value, the order value of the ACL remains the same
in the group-policy list.
Description
Use spt-switch-threshold infinity to disable the switchover to SPT.
Use undo spt-switch-threshold to restore the default.
By default, the device switches to the SPT immediately after it receives the first multicast packet.
To adjust the order of an existing ACL in the group-policy list, you can use the acl-number argument to
specify this ACL and set its order-value. This inserts the ACL to the position of order-value in the
group-policy list. The order of the other existing ACLs in the group-policy list remains unchanged.
139