Overflow-Replace (Mld-Snooping View); Report-Aggregation (Mld-Snooping View) - HP 3600 v2 Series Command Reference Manual

Examples
# Enable MLD snooping in VLAN 2, and specify MLDv2 snooping.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping version 2

overflow-replace (MLD-snooping view)

Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
View
MLD-snooping view
Default level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094. If you do not specify any VLAN, the command applies to all VLANs. If you specify one
or multiple VLANs, the command applies to the specified VLANs only.
Description
Use overflow-replace to enable the IPv6 multicast group replacement function globally.
Use undo overflow-replace to disable the IPv6 multicast group replacement function globally.
By default, the IPv6 multicast group replacement function is disabled globally.
For the HP 3600 v2 EI switches, this command takes effect in both MLD snooping-enabled VLANs and
VLANs with MLD enabled on their VLAN interfaces.
For the HP 3600 v2 SI switches, this command takes effect in MLD snooping-enabled VLANs.
Related commands: mld-snooping overflow-replace.
Examples
# Enable the IPv6 multicast group replacement function globally in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] overflow-replace vlan 2

report-aggregation (MLD-snooping view)

Syntax
report-aggregation
284