HP XP P9500 Manual page 78

Table 13 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKM7x) (continued)
Message ID
YKM775E ISPF
YKM776E ISPF
YKM900E ISPF
Table 14 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKM9x)
Message ID
YKM901E TSO
YKM902E TSO
YKM903E TSO
YKM904E TSO
78 Messages
Message Text
Panel could not proceed the
insert action because number
of the route entry has reached
maximum.
Route Label must be a
combination of one or more
qualifiers. Each qualifier must
be 1-8 alphanumeric
characters (0-9, A-Z, a-z) with
the first character being an
alphabetic character (AZ, a-z).
The length of Route Label must
be 1-8.
Start YKSTART command.
Message Text
ISPF service is not available.
Load module is not found.
SELECT service terminated
abnormally. RC=nn
Message library was not
found.
Explanation and Recommended Actions
The storage system cannot be added because the number of
storage systems defined in the route is already at the maximum.
The route label must be a combination of one or more qualifiers.
Each qualifier must be from 1 to 8 alphanumeric characters
(0-9, A-Z, a-z), and must start with an alphabetic character (A-Z,
a-z). The length of the route label must be from 1 to 8 characters.
Start the YKSTART command.
Explanation and Recommended Actions
The ISPF service is not available.
Execute the YKSTART command in an ISPF environment.
After that, you can execute whichever Business Continuity
Manager commands you need to.
The Business Continuity Manager load module was not found.
The Business Continuity Manager dataset might not be
concatenated to the LNKLST.
Revise the settings for the LNKLST, and then execute the
YKSTART command.
After that, you can execute whichever Business Continuity
Manager commands you need to.
The SELECT service terminated abnormally with the return code
nn.
If this message is displayed immediately after executing the
YKSTART command, the Business Continuity Manager dataset
might not be concatenated to the panel library (dd name:
ISPPLIB), the table library (dd name: ISPTLIB), or the REXX exec
library (dd name: SYSEXEC).
If DBCS (Double-Byte Character Set) is enabled for the
environment, concatenate the Business Continuity Manager
dataset to the alternate panel library (dd name: ISPPALT). For
details, see the HP P9000 for Business Continuity Manager
Software Installation Guide.
nn
Return code of the service
The message library was not found.
The Business Continuity Manager dataset might not be
concatenated to the message library (dd name: ISPMLIB).
If DBCS (Double-Byte Character Set) is enabled for the
environment, concatenate the Business Continuity Manager
dataset to the alternate message library (dd name: ISPMALT).
For details, see the HP P9000 for Business Continuity Manager
Software Installation Guide.