Message Output Destination; List Of Messages - HP XP P9500 Manual

Message Output Destination

The following destinations appear in messages issued by Business Continuity Manager:
MSG: Message structure
TSO: TSO/E terminal
CON: Console
SYS: SYSLOG
PRT: SYSPRINT or SYSTSPRT
LOG: ISPF log
ISPF: ISPF panel
XML: HP P9000 Command View Advanced Edition Software log and window
#
If MSGID ON is specified using the ISPF system command, the message ID and message text
are displayed in the ISPF panel. However, if MSGID OFF is specified, only the message text is
displayed at the beginning without the message ID.
If the sequence of REXX message variables is specified correctly in the MSG parameter common to
all CLI commands, the message will be saved in the sequence.
If the MSG parameter is specified incorrectly, or an error occurs while the CLI command is using
the REXX interface, the message will be sent to the user's TSO/E terminal.
For details about the CLI commands, see the HP P9000 for Business Continuity Manager Software
Reference Guide.

List of Messages

This section describes messages output by Business Continuity Manager and corresponding
troubleshooting actions.
Table 1 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YK80x)
Message ID
YK8001I CON
YK8002I CON
YK8003I PRT CON
YKJ213E TSO
YK8007I PRT CON
#
Message Text
BCM Monitor started.
(v.r.m-nn)
BCM Monitor terminated.
time BCM Monitor stopped
monitoring Copy Groups.
time Synchronization
percentage decreased,
Copy Group: cgid.
Explanation and Recommended Actions
BCM Monitor has started.
v.r.m-nn
Version and revision number
BCM Monitor has stopped.
BCM Monitor set the monitoring status of all copy groups to
INACTIVE.
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
The copy progress percentage for the copy group identified by
cgid is decreasing.
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
Message Output Destination 7