HP XP P9500 Manual page 235

Table 66 Details of Error Codes EBxx (continued)
Error Error Details
Code
A Cnt Ac-J Z copy pair status
EBA0
cannot be changed because the
specified S-VOL is not installed.
A Cnt Ac-J Z copy pair cannot be
EBA7
made because the THP Z volume
specified for the S-VOL satisfies
one of thefollowing conditions:
The capacity is being
expanded.
The pages are being released.
The pool of the corresponding
THP Z is being initialized.
The command could not be
EBA8
executed because the remote
command has been issued to a
volume that is not installed.
The remote command cannot be
EBB3
executed because the command
device has not been defined.
The command could not be
EBBD
executed because the command
device is under LDEV guard.
A delta resync pair cannot be
EBC6
made because the S-VOL of the
specified copy pair is used by
another program product (BC
Z/FlashCopy).
A Cnt Ac-J Z copy pair cannot be
EBCE
resynchronized (with the
DELTAJNL parameter) because
the specified S-VOL has old
differential information. Execute
the Cnt Ac-J Z copy pair
resynchronization (with the
ALLJNL parameter).
The remote command cannot be
EBD0
executed because the path
between the specified storage
system or CU (SSID) and the
command target storage system
is not set, or because an error has
occurred on the path.
The path for the remote command
EBD3
transfer route for the second site
onwards, or for the command
device, might not be set, or a
failure occurred in the remote
command transfer route. Make
sure that the path and the
command device are set,
available, and have not failed,
and then re-execute the operation.
Type of Error
BC Z Cnt Ac-S Z
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
TCA Cnt Ac-J Z CMD
Output Not output
Output Not output
Output Not output
Output
Output
Output Not output
Output Not output
Details of Error Codes 235
PATH Others
Not output
Not output
Output
Output