HP XP P9500 Manual page 66

Table 10 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKL2x) (continued)
Message ID
YKL281E MSG
SC=36 RC=36
(file:rec#)
YKL282E MSG
SC=36 RC=36 (file)
YKL283E MSG
SC=36 RC=36 (file)
YKL284E MSG
SC=36 RC=36
(file:rec#)
YKL290E MSG
SC=44 RC=44
(result)
YKL291E MSG
SC=36 RC=36
66 Messages
Message Text
No command devices are
defined for routes that issue
remote commands or for route
labels.
The route label specified for
the ROUTE parameter has not
been defined.
A route label is not specified
for the ROUTE parameter,
even though a route label is
defined for all the command
devices.
PVOL & SVOL of BC pair is
in the different storage
system.
YKVGET program failure for:
vn
function-name is not licensed
for use on this system.
Explanation and Recommended Actions
No command device was found that is defined in the route for
remote command issuance or with the specified route label.
Correct the route definition in the route list definition file identified
by file.
file
Name of the XML file where the error was
detected
rec#
Number of the line in the file identified by file
where the error was detected
The route label specified for the ROUTE parameter is not defined.
Correct the route definition in the route list definition file identified
by file.
file
Name of the XML file where the error was
detected
An attempt was made to load command device lines for which
no route label is specified because no route label is specified for
the ROUTE parameter. However, route labels are defined for all
the command devices in the route list definition file shown in file.
Set an appropriate route label for the ROUTE parameter of the
YKLOAD command, or use the Edit Attribute panel to delete the
route labels of command devices in the route list definition file
shown in file.
file
Name of the XML file where the error was
detected
In a file for a copy group of the BC Z copy type, a copy pair has
been discovered for which the storage system serial numbers of
the P-VOL and S-VOL do not match.
Correct the line with the line number identified by rec# in the file
identified by file.
file
Name of the XML file where the error was
detected
rec#
Number of the line in the file identified by file
where the error was detected
An attempt to acquire the variable vn failed with the result value
identified by result. This error can be caused by an invalid value
being specified for the STEM parameter.
The license key for the function identified by function-name has
not been installed, has expired, or is not correctly recognized.
Check whether the license key is available for this version.
If function-name is This product:
Business Continuity Manager commands cannot be used because
the Business Continuity Manager license key has not been installed.