HP XP P9500 Manual page 47

Table 8 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKG2x) (continued)
Message ID Message Text
YKH002I TSO No copy pair was
discovered.
YKH100E TSO Missing or invalid
parameter: parameter-name
YKH101E TSO The specified PREFIX is
being used by another
program.
YKH102E TSO Error occurred during
execution. Cmd=info
msg=message-text:
message-value:
message-severity
YKH200W TSO No information was
acquired for DEVN=Devn
Explanation and Recommended Actions
No copy pairs were detected within the specified range.
Check the operating range and status of the copy pair that you
want to acquire, and execute the YKH2B command again. If the
copy pair status is SIMPLEX, the YKH2B command will not detect
the copy pair. Note that if you specified HYPERDELTA(CHECK)
and HyperSwap is disabled, the YKH2B command will not detect
any copy pairs. In addition, if you execute the YKH2B command
without specifying the HS parameter or execute the YKH2B by
specifying HS(CHECK) while HyperSwaps are disabled, copy pairs
cannot be detected.
Check the following, and then re-execute the command:
Make sure that the required parameter indicated by
parameter-name was specified.
Make sure that the value specified for the required parameter
indicated by parameter-name is valid.
parameter-name
Name of the invalid or missing parameter
The specified prefix is being used by another program.
Check the value specified for the prefix.
An error occurred during execution of the YKH2B command.
See the explanation corresponding to the message ID of the error
message indicated by message-text and take appropriate action.
Also see the additional information indicated by message-value
and message-severity and take appropriate action. If the problem
is not resolved, contact service representative.
info
Maintenance information
message-text
Error message
message-value
Additional information about the error message
If no additional information is available, a space
is displayed.
message-severity
Additional information about the error message
If no additional information is available, a space
is displayed.
The error messages message-text, message-value, and
message-severity are displayed in the TSO/E terminal. Depending
on the length of the error messages, they might extend over several
lines.
No copy pair information was acquired from the volume with the
device number indicated by Devn. There might not be a volume
for the specified device number.
If a volume does exist for the specified device number, check the
channel settings.
Devn
Device number assigned to the volume from
which no copy pair information was acquired
List of Messages 47