HP XP P9500 Manual page 129

Table 37 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ21x – YKZ24x) (continued)
Message ID
YKZ243E MSG SC=48
RC=48
YKZ244E MSG SC=36
RC=36
YKZ245E MSG SC=48
RC=48
YKZ246E MSG SC=48
RC=48
YKZ247E MSG SC=44
RC=44
YKZ248E MSG SC=44
RC=0
YKZ249E MSG SC=48
#
RC=48 (pair-index)
Message Text
Supplied parameters invalid
Storage system serial-number is not
found in Routelist.
CopyGroup attribute combination is
invalid.
This operation (operation) does not
support remote command.
STEM(stem) information for Core
Processing is not found.
Necessary information for Core
Processing is not stored. (STEM =
stem)
Specified DAD or ROUTE is invalid.
Explanation and Recommended Actions
Check the status of the volumes in the copy group,
correct the YKRESYNC command parameter
specification, and then re-execute the command.
When executing the YKRESYNC command with the
FORWARD/REVERSE parameter, execute the
YKQUERY command or YKEWAIT command to
acquire the status of the copy pairs immediately
before the YKRESYNC command.
ATTIME or CANCEL is specified together with SVOL.
Correct the YKSUSPND command parameter values,
and then re-execute the command.
The specified storage system does not exist in the
route list.
serial-number
Storage system serial number
The combination of the specified command or the
operand, and copy group attribute is invalid.
Check the configuration file to make sure that the
configuration allows command execution, and
execute the command again.
This operation is not supported when a remote
function is in use.
operation
Operation name
Information on the specified stem name is missing.
The YKLOAD command has not been executed or the
stem name does not match the stem name specified
for the YKLOAD command.
stem
Stem name
Certain information required for CLI command
execution has not been registered.
Execute the YKLOAD command to register the
information.
#
stem
Stem name
#
The (STEM = stem) portion is displayed only when
the stem is obtained.
The DAD or ROUTE parameter specified on the
YKLOAD command is invalid.
Correct the specification.
pair-index
See the pair index description in
the explanation of the YKE003E
message.
List of Messages 129