HP XP P9500 Manual page 150

Table 43 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ3x) (continued)
Message ID
YKZ350T TSO RC=16
YKZ351E TSO RC=16
YKZ352E TSO RC=16
YKZ353E TSO RC=64
YKZ354I TSO RC=8
YKZ370E MSG SC=32
RC=32
YKZ371I TSO
Table 44 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ40x)
Message ID
YKZ400E MSG SC=48
RC=48
150 Messages
Message Text
Invalid parameters have been
specified.
No error code has been specified.
The specified error code is invalid.
Load module is not found.
A description for the specified error
code was not found.
A dynamic configuration change was
detected during specified command
processing. DEVN device#
YKENV command return
code=return-code.
Message Text
param parameter cannot be
specified for copy-type Copy Group.
Explanation and Recommended Actions
Invalid parameters have been specified.
No error code has been specified.
The specified error code is invalid. A possible cause
is as follows:
The specified value is not a four-digit hexadecimal
value.
The load module cannot be found. Possible causes
are as follows:
The library dataset has not been concatenated.
The module is protected by the RACF program
control function.
A description for the specified error code was not
found.
For details on error codes, see
Sense Byte Information" (page
is not listed in the manual, contact maintenance
personnel.
A dynamic change in an I/O configuration definition
was detected during processing of the command.
Check the status of the device targeted by the
command, correct any errors related to the
configuration or execution conditions, and then
re-execute the command.
device#
Device number being processed
when a dynamic change was
detected in an I/O configuration
definition
The YKENV command terminated.
return-code
Return code issued by the YKENV
command
Explanation and Recommended Actions
The parameter indicated by param cannot be
specified for a copy group with a copy type of
copy-type.
Check the copy type and the parameter.
param (string)
The parameter name which
cannot be specified
copy-type (string)
"Storage System
165). If the error code