HP XP P9500 Manual page 156

Table 45 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ41x) (continued)
Message ID
YKZ41 1E MSG SC=36
RC=48
YKZ412E MSG SC=36
RC=48
YKZ413E MSG SC=36
#1
RC=36
156 Messages
Message Text
CAJ parameter is only valid for BC Z
Copy Groups with C/T ID.
This device SUPFnc does not support
CAJ ATTIME.
Copygroup SUPFnc does not support
the timestamp transfer mode.
Explanation and Recommended Actions
used in the copy group
(minimum)
#1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
#2
The Errorlevel for Cnt Ac-J Z can be used in a
storage system where the version of the storage
system support function is X'12' or higher.
The YKSUSPND command with the ATOPT(CAJ)
parameter specified was executed on a copy group
other than an BC Z copy group with the C/T group
ID specified. The ATOPT(CAJ) parameter is only
valid on BC Z copy groups with the C/T group ID
specified.
Re-execute the YKSUSPND command without
specifying the ATOPT parameter, or with the
ATOPT(NORMAL) parameter specified.
The CAJ ATTIME suspend function is not available
for this storage system.
#
Use a device for which the CAJ ATTIME suspend
function is supported. Also, if scanning was not
performed after the storage system microcode was
replaced, perform another scan.
SUPFnc (hexadecimal number)
Value for the version of the
storage system support function
used in the copy group
(minimum)
#
The CAJ ATTIME suspend function can be used
in a storage system where the version of the storage
system support function are X'14' or higher.
The timestamp transfer mode cannot be used with
this storage system.
#2
Use a device that supports the timestamp transfer
mode. Also, if scanning was not performed after
the storage system microcode was replaced,
perform another scan.
SUPFnc (hexadecimal number)
Value for the version of the
storage system support function
used in the copy group
#1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
#2
The timestamp transfer mode can be used for the
storage system models listed below. You cannot use
the timestamp transfer mode when using the
XP1024/XP128 disk array.
XP12000/XP10000 disk arrays
Version of the storage system support function:
X'16' or higher
XP24000/XP20000 disk arrays
Version of the storage system support function:
X'21' or higher