System Snmp Traps Commands; Add - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

4.18.1 System SNMP Traps add Command

add

System SNMP Traps Commands

Adds SNMP traps.
Syntax
add [v1v2c|v3]
add v1v2c <ip> <port> <comm> <ver>
add v3 <ip> <port> <user> <sec> <auth> <pass1> <priv> <pass2>
Parameters
v1v2c <ip> <port>
<comm> <ver>
v3 <ip> <port> <user>
<sec> <auth> <pass1>
<priv> <pass2>
Example
admin(system.snmp.traps)>add v1v2 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>list v1v2c
----------------------------------------------------------------------
index dest ip
----------------------------------------------------------------------
1 203.223.24.2
admin(system.snmp.traps)>add v1v2 209.255.32.1 334 jumbo v2
admin(system.snmp.traps)>list v1v2c
----------------------------------------------------------------------
index dest ip
----------------------------------------------------------------------
1 203.223.24.2
2 209.255.32.1
Adds an SNMP v1/v2c trap entry.
• <ip> – The destination IP address
• <port> – The destination UDP port number.
• <comm> – The community
• <ver> – The SNMP version number.
Adds an SNMP v3 trap entry.
• <ip> – The destination IP address
• <port> – The destination UDP port number.
• <user> – The username
• <sec> – The security type. <sec> is set to one of none, auth, or auth/priv.
The following parameters must be specified if <sec> is set to auth/priv:
• <auth> – The authentication algorithm. Can be one of
be set if <sec> is set to
• <pass1> – The password
provided if <sec> is set to
• <priv> – The privacy algorithm. Set to
set to auth/priv.
• <pass2> – Privacy password
is set to auth/priv.
dest port
333
dest port
333
334
System CLI Commands Reference
(1–31 characters)
(v1 or v2)
(1–31 characters).
auth or auth/priv.
(8–31 characters) for authentication. Must be
auth or auth/priv.
des or aes. Must be set if <sec> is
(8–31 characters). Must be provided if <sec>
community
mycomm
community
mycomm
jumbo
4-79
md5 or sha1. Must
version
v1
version
v1
v2