Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-120 WS2000 Wireless Switch System Reference Guide
3.23.2 Network WAN set Command

set

Network WAN Commands
Sets the WAN parameters. In the Web interface, this functionality if provided by the Network->WAN screen.
Syntax
set [dhcp|dgw|dns|ipadr|mask|mode|ppope|mtu]
Parameters
dhcp <mode>
dgw <a.b.c.d>
dns <idx> <a.b.c.d>
ipadr <idx> <a.b.c.d>
mask <a.b.c.d>
mode <idx> <mode>
pppoe [idle|ka|mode|passwd|
type|user|mss]
mtu
Example
admin(network.wan)>set dhcp enable
admin(network.wan)>set dgw 192.168.122.25
admin(network.wan)>set pppoe mode enable
admin(network.wan)>set pppoe type chap
admin(network.wan)>set pppoe user JohnDoe
admin(network.wan)>set pppoe passwd @#$goodpassword%$#
Enables or disables the switch as a DHCP client. <mode> can be one of
enable or disable.
Sets the default gateway IP address to <a.b.c.d>.
Sets the IP address of one or two DNS servers, where <idx> indicates
either the primary (1) or secondary (2) server, and <a.b.c.d> is the IP
address of the server.
Sets up to 8 (using <idx> from
interface of the switch.
Sets the subnet mask to <a.b.c.d>.
Enables or disables the WAN interface associated with the given <idx> (1–
8) as set using the set ipadr command. <mode> can be one of
disable.
Sets PPPoE parameters.
• idle <val> – Sets the PPPoE idle value <val> (1–65535) seconds.
• ka <mode> – Sets the PPPoE keep alive mode <mode> (enable,
disable).
• mode <mode> – Enables or disables PPPoE. <mode> can be one of
enable or disable.
• passwd <password> – Sets the PPPoE password to <password>
Characters)
• type <type> – Sets the PPPoE authentication type to <type> (none,
chap, pap, chap).
• user <username> – Sets the PPPoE user name to <username>
Characters).
• mss <msssize> – Sets the PPPoE maximum segment size to <msssize>
(20–1460).
Sets MTU size of wan interface. The minimum value is 128 bytes and
maximum is 1500 bytes.
1 to 8) IP addresses <a.b.c.d> for the WAN
enable or
(1 – 39
pap/
(1 – 47