Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-220 WS2000 Wireless Switch System Reference Guide
3.41.2 Network WLAN Hotspot RADIUS set Command

set

Network WLAN Hotspot RADIUS commands
Configures the RADIUS server information for hotspots for each WLAN.
Syntax
set [server|port|secret|acct-mode|acct-timeout|acct-retry|
bind-interface|auth-mode]
set server <idx> <srvr_type> <ipadr>
set port <idx> <srvr_type> <port>
set secret <idx> <srvr_type> <secret>
set acct-mode <idx> <mode>
set acct-timeout <idx> <timeout>
set acct-retry <idx> <retry_count>
set bind-interface <idx> <server> <interface>
set auth-mode <idx> <mode>
Parameters
server <idx> <srvr_type>
<ipadr>
port <idx> <srvr_type> <port>
secret <idx> <srvr_type
<secret>
acct-mode <idx> <mode>
acct-timeout <idx> <timeout>
acct-retry <idx> <retry-count>
bind-interface <idx> <server>
<interface>
auth-mode <idx> <mode>
Example
admin(network.wlan.hotspot.radius)> set server 1 primary 192.169.1.222
admin(network.wlan.hotspot.radius)> set server 1 secondary 192.169.1.223
admin(network.wlan.hotspot.radius)> set port 1 primary 1812
admin(network.wlan.hotspot.radius)> set port 1 secondary 1812
admin(network.wlan.hotspot.radius)> set secret 1 primary hello1
Sets the IP address <ipadr> of the RADIUS server for the WLAN with
index <idx> (1-8). The <srvr_type>
RADIUS server as a primary or a secondary server.
Sets the port <port> of the RADIUS server for the WLAN with the index
<idx> (1-8). The <srvr_type>
RADIUS server as a primary or a secondary server.
Sets the secret <secret> for accessing the RADIUS server for the WLAN
with the index <idx> (1-8). The <srvr_type>
identifies the RADIUS server as a primary or a secondary server.
Enables or disables accounting mode for the RADIUS server for the
WLAN with the index <idx> (1-8). When enabled, RADIUS accounting
log is written to the CF card when the RADIUS server is not reachable.
Sets the time duration <timeout> (1-255) seconds after which RADIUS
logs are written to the CF card.
Sets the number of re-tries <retry-count> (1-10) made before RADIUS
logs are written to the CF card.
Binds the RADIUS server type <server>
interface <interface> (one of s1-s6, w, none - s1- Subnet 1, s2-subnet 2,
...s6-Subnet 6, w-wan) for the WLAN <idx> (1–8).
Sets the radius authentication mode to either PAP or CHAP. This is used
to encrypt authentication packets when authenticating with radius
servers located on the WAN side of WS2000.
(primary, secondary) identifies the
(primary, secondary) identifies the
(primary, secondary)
(Primary or Secondary) to the