3-246 WS2000 Wireless Switch System Reference Guide
3.47.1 Network WIPS set Command
set
Network WIPS Default commands
Sets the default WIPS configuration settings. These settings are used when WIPS configurations are not
changed.
Syntax
set mode <mode>
set [ipaddr|mask|dgw|pwips|swips] <a.b.c.d>
Syntax:
mode <mode> Sets the default mode to
ipaddr
<a.b.c.d>
mask <a.b.c.d> Sets the network mask to <a.b.c.d> for the WIPS sensor
dgw <a.b.c.d> Sets the default gateway for the WIPS sensor to <a.b.c.d>
pwips
<a.b.c.d>
swips
<a.b.c.d>
Example
admin(network.wips.default)> set mode enable
admin(network.wips.default)> set ipaddr 192.168.0.10
admin(network.wips.default)> set mask 255.255.255.0
admin(network.wips.default)> set dgw 192.168.0.1
admin(network.wips.default)> set pwips 192.168.0.20
admin(network.wips.default)> set swips192.168.0.21
admin(network.wips.default)> show
DHCP Mode
IP Address
IP Mask
Default Gateway
Primary WIPS Server
Secondary WIPS Server
enable
Sets the IP address to <a.b.c.d> for the WIPS sensor.
Sets the primary WIPS server to <a.b.c.d>
Sets the secondary WIPS server to <a.b.c.d>.
: client
: 192.168.0.10
: 255.255.255.0
: 192.168.0.1
: 192.168.0.20
: 192.168.0.21
or
disable.