Update - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

4.4.7 System Config update Command

update

System Configuration Commands
Performs a firmware update.
Syntax
update <mode> {<interface>}
update [tftp|ftp|sftp] <interface>
update cf
Parameters
update [tftp|ftp|sftp]
<iface>
update cf
Example
admin(system.config)>set fw file mf_01050000200B.bin
admin(system.config)>set fw path /tftp/myadmin/
admin(system.config)>update tftp s1
Sets how firmware updates will occur. Select between
<iface> specifies the interface (location), as follows:
• s1 = subnet1
• s2 = subnet2
• s3 = subnet3
• s4 = subnet4
• s5 = subnet5
• s6 = subnet6
• w = wan
Before using this command, use set server to set the IP address for the FTP/TFTP
server. If using the ftp mode, also use set user and set passwd to allow login to
the FTP server.
Note: When update mode is sftp,then the parameter 'iface' is not required.
Indicates that firmware updates will occur from the switch's compact flash slot.
(Undoes an ftp/tftp/sftp setting.)
System CLI Commands Reference
ftp, sftp and tftp.
4-19