Set - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-142 WS2000 Wireless Switch System Reference Guide
3.27.4 Network WAN NAT set Command

set

Network WAN NAT Commands
Sets NAT inbound and outbound parameters.
Syntax
set [inb|outb|type]
Parameters
inb [mode|ip]
outb [ip|map]
type <idx> <type> Sets the type of NAT translation for WAN address index <idx> (1–8) to one of none,
Example
admin(network.wan.nat)>set type 1 1-to-1
admin(network.wan.nat)>set outb ip 1 209.239.44.36
admin(network.wan.nat)>set inb mode 1 enable
admin(network.wan.nat)>show nat 1
nat type
one to one nat ip address
port forwarding mode
port forwarding ip address
one to many nat mapping
Sets the inbound NAT parameters.
• mode <idx> <mode> – Sets the inbound NAT mode for the WAN with index <idx>
(1–8). <mode> can be one of
• ip <idx> <a.b.c.d> – Forward unspecified ports and to the IP <a.b.c.d> for the WAN
with index <idx> (1–8).
Sets the outbound NAT parameters.
• ip <idx> <a.b.c.d> – Sets 1-to-1 NAT IP mapping entries where <idx> (1–8) is the
index of the WAN to the ip address <a.b.c.d>.
• map <from> <to> – Sets 1-to-many NAT mapping entries where <from> is one of s1,
s2, s3, s4, s5, and s6. <to> is the Wan index (1–8) or none.
1-to-1, or 1-to-many.
enable or disable.
: 1-to-1
: 209.239.44.36
: enable
: 0.0.0.0
: subnet1 subnet2 subnet3 subnet4 _