Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual page 187

set ipsecdel <name> <mode>
set auto-initiation <name> <mode>
set auto-initiate-interval <interval>
Parameters
ike myidtype <name> Sets the Local ID type for IKE authentication for SPD <name>
<idtype> to <idtype> (one of IP, FQDN, or UFQDN).
ike remidtype <name> Sets the Remote ID type for IKE authentication for SPD <name>
<idtype> characters) to <idtype> (one of IP, FQDN, or UFQDN).
ike myiddata <name> Sets the Local ID data for IKE authentication for SPD <name>
<iddata> to <iddata>. This value is not required when the ID type is set to IP.
ike remiddata <name> Sets the Remote ID data for IKE authentication for SPD <name>
<iddata> characters) to <idtype>.
ike opmode <name> Sets the Operation Mode of IKE for SPD <name>
<opmode> <opmode> can be one of
ike authtype <name> Sets the IKE Authentication type for SPD <name>
<authtype> <authtype> (one of
ike authalgo <name> Sets the IKE Authentication Algorithm for SPD <name>
<authalgo> <authalgo>. <authalgo> can be either
ike psk <name> <psk> Sets the IKE Pre-Shared Key for SPD <name>
characters).
ike encalgo <name> Sets the IKE Encryption Algorithm for SPD <name>
<encalgo> <encalgo> (one of DES, 3DES, AES128, AES192, or AES256).
ike lifetime <name> Sets the IKE Key life time in seconds for SPD <name>
<lifetime> <lifetime> seconds.
ike group <name> Sets the IKE Diffie-Hellman Group for SPD <name>
<group> <group> (one of
type <name> <type> Sets the authentication type of SPD <name>
or Manual).
sub <name> <sub> Sets the Local Subnet (1, 2, 3, 4,
subnet number <sub> (1, 2, 3, 4,
remip <name> <remip> Sets the IP address for the remote end of SPD <name>
remote ip <remip> (a.b.c.d).
remmask <name> Sets the IP Mask for the remote end of SPD <name>
<remmask> <remmask> (a.b.c.d).
remgw <name> Sets the Remote IP gateway for SPD <name>
<remgw> (a.b.c.d).
Set this value to 0.0.0.0 to support tunneling to VPN peer which is a DHCP client.
authalgo <name> Sets the authentication algorithm for SPD <name>
<authalgo> <authalgo> (one of None, MD5, or SHA1).
Main or Aggr(essive).
PSK or RSA).
MD5
G768 or G1024)
5 or 6) for SPD <name>
5 or 6).
Network CLI Commands Reference
(1 to 13 characters)
(1 to 13
(1 to 13 characters)
(1 to 13
(1 to 13 characters) to 4.
(1 to 13 characters) to
(1 to 13 characters) to
or SHA1.
(1 to 13 characters) to <psk>
(1 to 13 characters) to
(1 to 13 characters) to
(1 to 13 characters) to
(1 to 13 characters) to <type>
(1 to 13 characters) to
(1 to 13 characters) to
(1 to 13 characters) to
(1 to 13 characters) to be <remgw>
(1 to 13 characters) to
3-151
(1–49
(Auto