3.9.1 Network AP Mesh set Command
set
Network AP Mesh Commands
Sets the mesh related parameters.
Syntax
set [client|vlan|auto|base|max-clients]
Parameters
client <radio-idx>
[enable|disable]
wlan <radio-idx> <wlan-id> Selects the WLAN <wlan-id> (1-8) for the mesh client radio index
auto <radio-idx>
[enable|disable]
base <radio-idx>
[enable|disable]
max-clients <radio-idx>
<max-clients>
Example
admin(network.ap.mesh)> set client 1 enable
admin(network.ap.mesh)> show 1
-------------------------------------------------------------------------
"Mode"
-------------------------------------------------------------------------
Client Only
admin(network.ap.mesh)> set base 1 enable
admin(network.ap.mesh)> show 1
-------------------------------------------------------------------------
"Mode"
-------------------------------------------------------------------------
Base and Client
admin(network.ap.mesh)> set wlan 1 3
admin(network.ap.mesh)> show 1
-------------------------------------------------------------------------
"Mode"
-------------------------------------------------------------------------
Base and Client
admin(network.ap.mesh)> set max-clients 1 4
admin(network.ap.mesh)> show 1
-------------------------------------------------------------------------
"Mode"
-------------------------------------------------------------------------
Base and Client
Enables or disables the mesh client for the radio with the index
<radio-idx> (1-12).
<radio-idx> (1-12).
Enables or disables automatic base selection for the radio with the index
<radio-idx> (1-12).
Enables or disables the radio <radio-idx> (1-12) as the mesh base.
Sets the maximum number of client <max-clients> for the radio
<radio-idx> (1-12).
"WLAN"
"Base Auto Selection" "Max Clients"
WLAN1
Enabled
"WLAN"
"Base Auto Selection" "Max Clients"
WLAN1
Enabled
"WLAN"
"Base Auto Selection" "Max Clients"
WLAN3
Enabled
"WLAN"
"Base Auto Selection" "Max Clients"
WLAN3
Enabled
Network CLI Commands Reference
N/A
6
6
4
3-41