Show - Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual

3-90 WS2000 Wireless Switch System Reference Guide
3.17.2 Network LAN show Command

show

Network LAN Commands
Shows the LAN parameters.
Syntax
show [lan|stp]
Parameters
lan <idx>
stp
Example
admin(network.lan)>show lan 1
subnet name
subnet interface
ip address
network mask
ports
wlans
admin(network.lan)>set name 1 NewName
admin(network.lan)>set port 4 none
admin(network.lan)>set wlan 2 s1
admin(network.lan)>show lan 1
subnet name
subnet interface
ip address
network mask
ports
wlans
admin(network.lan)> set stp enable
admin(network.lan)> show stp
STP Mode
Related Commands
set Sets the parameters for a specified subnet (LAN).
set stp Enables or disables Spanning Tree Protocol for the device.
Shows the settings for the subnet <idx> (1–4).
Shows the STP status for the device
: Subnet1
: enable
: 192.168.0.1
: 255.255.255.0
: port1 port2 port3 port4 port5 port6
: wlan1
: NewName
: enable
: 192.168.0.1
: 255.255.255.0
: port1 port2 port3 port5 port6
: wlan1 wlan2
: Enable