Motorola WS2000 - Wireless Switch - Network Management Device Cli Reference Manual page 212

3-176 WS2000 Wireless Switch System Reference Guide
eap server <idx> <rsidx> <ip> Sets the RADIUS server <rsidx> (1-primary or 2-secondary) for WLAN
eap port <idx> <rsidx> <port> Sets the RADIUS server <rsidx> (1-primary or 2-secondary) for WLAN
eap rad-acct mode <idx>
<mode>
eap rad-acct retry-count <idx>
<count>
eap rad-acct timeout <idx>
<time>
eap rad-bind-interface <idx>
<server> <interface>
eap reauth mode <idx> enable/
disable
eap reauth period <idx>
<period>
eap reauth retry <idx> <retry> Sets the maximum number of reauthentication retries to <retry> (1–99)
eap secret <idx> <rsidx>
<secret>
eap syslog ip <idx> <ip>
eap syslog mode <idx> enable/
disable
enc <idx> <type>
ess <idx> <ess>
kerb passwd <idx>
<password>
kerb port <idx> <ksidx> <port> Sets the Kerberos port to <port> (KDC port) for server <ksidx> (1-primary,
kerb realm <idx> <realm>
kerb server <idx> <ksidx> <ip> Sets the Kerberos server <ksidx> (1-primary, 2-backup, or 3-remote) IP
kerb user <idx> <name>
mcast <idx> <midx> <mic>
mode <idx> <mode>
name <idx> <name>
<idx> (1–8) to IP address <ip>.
<idx> (1–8) to <port>.
Enables/disables RADIUS accounting for WLAN <idx> (1–8).
Sets RADIUS accounting retry count to <count> (1–10) for WLAN <idx>
(1–8).
Sets RADIUS accounting retry timeout to <time> seconds (1–255) for
WLAN <idx> (1–8). 0 indicates no timeout.
Binds the RADIUS server type <server>
interface <interface> (one of s1-s6, w, none - s1- Subnet 1, s2-subnet 2,
...s6-Subnet 6, w-wan) for the WLAN <idx> (1–8).
Enables or disables the EAP reauthentication parameters for WLAN <idx>
(1–8).
Sets the reauthentication period for WLAN <idx> (1–8) to <period>
seconds (30–9999).
for WLAN <idx> (1–8).
Sets the EAP shared secret <secret> (1–127 characters) for server
<rsidx> (1-primary or 2-secondary) on WLAN <idx> (1–8).
Note: Kerberos parameters are only in effect if "kerberos" is specified for the
authentication method (set auth <idx> <type>).
Sets the remote syslog server for WLAN <idx> (1–8) to the IP address
<ip> (a.b.c.d).
Enables/disables remote syslog for WLAN <idx> (1–8).
Sets the encryption type to <type> (one of none, wep40, wep104,
keyguard, tkip, or ccmp) for WLAN <idx> (1–8).
Note: TKIP parameters are only in effect if "tkip" is selected as the encryption
type.
Sets the 802.11 ESS ID for WLAN <idx> (1–8) to <ess>.
Sets the Kerberos password to <password> (1–21 characters) for WLAN
<idx> (1–8).
2-backup, or 3-remote) for WLAN <idx> (1–8).
Sets the Kerberos realm name for WLAN <idx> (1–8) to <realm> (1–63
characters).
address for WLAN <idx> (1–8) to <ip>.
Sets the Kerberos user name for WLAN <idx> (1–8) to <name> (1–21
characters).
Sets the multicast group address <midx>
(1, 2) for WLAN <idx> (1–8) to MAC address <mac>.
Enables or disables WLAN <idx> (1–8).
Sets the name of WLAN <idx> (1–8) to <name> (1–7 characters).
(1 - Primary, 2 - Secondary) to the