4.4.9 System Config loadtocf Command
loadtocf
System Configuration Commands
This command loads and updates the firmware to the CF card. This is used for dual boot.
Syntax
loadtocf [cf|ftp|tftp|sftp] <image-type>
Syntax:
cf <image-type>
ftp <image-type>
tftp <image-type>
sftp <image-type>
Example
admin(system.config)> loadtocf cf primary
admin(system.config)>
Loads the image to the CF card. The <image-type>
target partition on the CF card to store the image on. In this case, the image source
is the CF card and the destination is also the CF card.
Loads the image to a CF card. The <image-type>
target partition on the CF card to store the image on. This command downloads the
image using FTP and stores it on the target partition.
Loads the image to a CF card. The <image-type>
target partition on the CF card to store the image on. This command downloads the
image using TFTP and stores it on the target partition.
Loads binary image to cf using sftp.The <image-type>
target partition on the CF card to store the image on. This command downloads the
image using SFTP and stores it on the target partition.
System CLI Commands Reference
(primary,
secondary) is the
(primary,
secondary) is the
(primary,
secondary) is the
(primary,
secondary) is the
4-21